|
ZLB medium and small axial flow pump generally has two rubber bearing, replace to replace them all, if the center of impeller pump line at the bottom of the pool distance is greater than thepump axis length is simple, 1, remove the horn. 2, remove the impeller nut (rotor head) remove the impeller. 3, open the rubber bearing, pay attention to remove the bolts, can use the top wire top of therubber bearing. 4, undo the packing gland. 5, loosen the rigid coupling. Careful attention to the pump shaft suddenly from falling, prevent scarred. 6, use tools to unload pump shaft coupling nut, remove just pump parts, 7, remove the packing gland, packing box, rubber bearing. 8, the joint surface cleaning, replacement of rubber bearings. As the impeller components can not continue to use the best and replace. 9, the impeller installed in the pump shaft is successively, must tighten the nut. 10, in the reverse order assembly. 11, from the packing gland above the gap manual watering or run water skiing, manual jigger. Ji'nan TEDA pump to provide customers with pump high temperature molten salt pump, high quality and efficiency of high temperature molten salt liquid pump, liquid pump, axial flow pump,high temperature molten salt axial flow pump, oil pump, and the corresponding supporting molten salt regulating valve (manual and automatic two kinds), welcome to contact our customers. Web site: www.jntdby.com E_mail:jntdby@163.com Tel: 0531-87970633 Fax:0531-87970632 |
Current Location：
